Articles in this section
Category / Section

How to disable the selection in WPF Diagram?

1 min read

You can disable Selection of Nodes and Connectors by removing selectable constraints in WPF Diagram (SfDiagram). Please refer to the code snippet as below.

C#

Code to disable the selection of SfDiagram

diagram.Constraints = diagram.Constraints & ~GraphConstraints.Selectable;

Code to disable the selection of particular Node and Connector

C#

//Here, node is the instance of Node.
node.Constraints = node.Constraints & ~NodeConstraints.Selectable;
 
//Here, connector is the instance of Connector.
connector.Constraints = connector.Constraints & ~ConnectorConstraints.Selectable;

 

Conclusion

I hope you enjoyed learning about how to disable the selection in WPF Diagram.

You can refer to our  WPF Diagram feature tour page to know about its other groundbreaking feature representations. You can also explore our WPF Diagram documentation to understand how to create and manipulate data.

For current customers, you can check out our components from the License and Downloads page. If you are new to Syncfusion, you can try our 30-day free trial to check out our other controls.

If you have any queries or require clarifications, please let us know in the comments section below. You can also contact us through our support forumsDirect-Trac, or feedback portal. We are always happy to assist you!

Did you find this information helpful?
Yes
No
Help us improve this page
Please provide feedback or comments
Comments (0)
Please  to leave a comment
Access denied
Access denied