How to deselect the chart segment by using code behind in UWP Chart?
This article describes how to deselect the chart segment or series by using code behind.
You can deselect the segment in code behind by setting the SelectedIndex property as shown in the following code example.
Series1.SelectedIndex = -1;
You can deselect the series in code behind by setting the SeriesSelectedIndex property as shown the following code example.
chart.SeriesSelectedIndex = -1;
I hope you enjoyed learning about how to deselect the chart segment by using code behind in UWP Chart.
You can refer to our UWP Chart feature tour page to know about its other groundbreaking feature representations. You can also explore our UWP Chart documentation to understand how to create and manipulate data.
If you have any queries or require clarifications, please let us know in the comments section below. You can also contact us through our support forums, Direct-Trac, or feedback portal. We are always happy to assist you!